WWA Info Exchange

For Woodworkers By Woodworkers
It is currently Sat Dec 16, 2017 6:17 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Flat
PostPosted: Fri Jun 02, 2017 8:28 am 
Offline
Veteran

Joined: Sun Feb 21, 1999 1:01 am
Posts: 2450
Location: Rochester MN USA
It seems to be good practice when working wood, to start with making the rough lumber straight flat and square. There are lots of cats in this scheme. When using tools, then, making them " straight, flat and square" should also be good practice. Edged tools are the backbone of many shop procedures and here is an article about making the plane and chisel edges perform as well as possible. When the tools perform optimally, then the goof is operator error :oops:

https://fairwoodworking.wordpress.com/2 ... 6-minutes/

This page is part of an ongoing discussion and the click throughs to read the previous and following pages will prove interesting.


Top
 Profile  
 
 Post subject: Re: Flat
PostPosted: Fri Jun 02, 2017 11:28 am 
Offline
Veteran

Joined: Sat Sep 06, 2003 12:01 am
Posts: 1885
Location: San Diego, CA USA
That's a great link.....Thanks!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: Yahoo [Bot] and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group