WWA Info Exchange

For Woodworkers By Woodworkers
It is currently Fri Aug 17, 2018 9:46 pm

All times are UTC - 5 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: If slapdash
PostPosted: Mon Dec 18, 2017 2:53 pm 
Offline
Veteran

Joined: Sun Feb 21, 1999 1:01 am
Posts: 2696
Location: Rochester MN USA
is a route to measurements, then the marking/cutting gauge is not the tool to use. It can be set from good measuring tools or even better set from the workpieces and sometimes the cutting tools themselves. Here is good poop in a scoop about marking/cutting gauges. You might even want to make one.

https://www.popularwoodworking.com/wp-c ... _Gauge.pdf

Making 1face and 1 edge the reference surfaces on all the work pieces usually prevents an ooops :roll:


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group