WWA Info Exchange

For Woodworkers By Woodworkers
It is currently Fri Nov 24, 2017 4:18 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Not a machinist?
PostPosted: Wed Jun 21, 2017 5:57 pm 
Offline
Veteran

Joined: Sun Feb 21, 1999 1:01 am
Posts: 2425
Location: Rochester MN USA
That's OK you can still turn threads on your project boxes or spindles. A little patience and the old standby "attention to detail" will see you proud.

http://www.fingerlakeswoodturners.com/d ... InWood.pdf

Without any experience doing so, I suspect that making your own chasing tools is quite possible.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group