WWA Info Exchange

For Woodworkers By Woodworkers
It is currently Tue Mar 19, 2024 4:55 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 5 posts ] 
Author Message
PostPosted: Sun Jun 24, 2018 2:13 pm 
Offline
Veteran

Joined: Thu Apr 15, 1999 12:01 am
Posts: 1359
Location: Albuquerque NM
Anybody have a factory cut wrap for this sander? I'm looking for the dimensions of the taper at the end of the roll. I've been cutting mine from long rolls and would like to know the "official" dimensions of the taper.


Top
 Profile  
 
PostPosted: Tue Jun 26, 2018 5:48 pm 
Offline
Veteran

Joined: Sun Dec 19, 2004 1:01 am
Posts: 4044
Location: Rolling Meadows, IL. USA
The best I can give you the end is angled at some where between 75 & 80* I do not have the over all length as that angle was off to the broken one.
mine is a Delta 31-250
Hope that helps.

FYI Manual
pdfstream.manualsonline.com/9/9dc3f8d7-2412-4512-ac35-5980f72d66de.pdf

_________________
"It is not a mistake it is a learning experience"
Monte


Top
 Profile  
 
PostPosted: Tue Jun 26, 2018 5:56 pm 
Offline
Veteran

Joined: Thu Apr 15, 1999 12:01 am
Posts: 1359
Location: Albuquerque NM
what's the width at the pointy end and how long is the bevel?
Thanks


Top
 Profile  
 
PostPosted: Tue Jun 26, 2018 6:50 pm 
Offline
Veteran

Joined: Sun Dec 19, 2004 1:01 am
Posts: 4044
Location: Rolling Meadows, IL. USA
2" wide belt
about 1 1/8" wide at blunt end of taper
along the taper about 4"
3 3/4" over all length of section
All of these are approximate demotions as long as it is in the neighborhood it will work, the one that is on there now was just rolled on and approximated.

_________________
"It is not a mistake it is a learning experience"
Monte


Top
 Profile  
 
PostPosted: Tue Jun 26, 2018 6:56 pm 
Offline
Veteran

Joined: Thu Apr 15, 1999 12:01 am
Posts: 1359
Location: Albuquerque NM
thanks.
as you suggest, anything "close" will work. I buy bulk rolls and trace the end from the one that came off the sander. Over time the shape has drifted and I thought it might be nice to get back to the original shape.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group